Selecting A Project - Roland VM-C7100 Owner's Manual

Selecting a project

More than one project may be stored on a memory card, allowing you to store
completely different console settings for each project. Select and switch projects by
following the procedure below.
After a project is selected, the console settings are replaced with that of the selected
project, removing the prior settings. Before switching to a new project, make sure to
store the current project on the card if you wish to retain it.
Selecting a project
1. Press [PROJECT], CURSOR [UP] and [F1] (SELECT), in that order.
This calls up the project select screen.
2. Select a project using the V1 knob (SELECT NUMBER).
3. Press [F2] (SELECT).
4. Press [F5] (OK) and then [F6] (EXIT) after selection is completed.
The following information can be referred to on the
project list.
fig.03-14
NAME: Project name (12 characters max. See p. 53.)
UPDATE: Date of update (according to internal clock at time of storing)
T: Type (number of consoles used by the project, 1 or 2)
P: Protect (protected from accidental erasure when the letter is checked.
See p. 53.)
"T" is automatically determined by the number of consoles connected when the
project is created. For a Type 2 project, the number of storable Scenes decreases by
half (50).
Chapter 3 Data Storage and Retrieval
55