Receiving Or Transmitting Level/Pan Using Fader Or Knobs; Example Of Connections; To Synchronize With An External Midi Device (The Console Is Used As A Slave) - Roland VM-C7100 Owner's Manual

Receiving or transmitting level/pan using fader or knobs

Change to the following screen by pressing [MULTI OUT] while holding [SHIFT]
down. Control Change messages are transmitted to an external device when you
operate the fader or knobs on this screen. This allows you to control the volume of the
MIDI device connected (LEVEL: Control Change Number 7) or panning (PAN:
Control Change Number 10).
fig.12-05

Example of Connections

To synchronize with an external MIDI device
(the console is used as a slave)
To synchronize with MTC (MIDI time code) transmitted from an external MIDI
device, connect up as shown below, and set the required parameters.
fig.12-01
Chapter 12 Using with MIDI Devices
When a MIDI device is
connected to the MIDI IN
connector of the processor,
the console does not
receive Control Change
messages sent from it.
Press [F1] to [F6] to turn off
the channels which do not
transmit Control Change
messages.
Press [F6] (SENDALL) to
transmit the current level
or panning of all channels
to the external MIDI
device.
The processor also has a
MIDI IN connector which
is used in the same way as
that on the console.
The MIDI clock transmitted
from an external MIDI
device does not cause the
console to synchronize.
225