Dual Mono Dynamics - Roland VM-C7100 Owner's Manual

Chapter 8 Using the Internal Effects

Dual Mono Dynamics

Although its configuration is almost the same as that of Stereo 2-Band Dynamics, it is monaural, designed for
channel insert. However, as the Link feature is provided, it can be used in the stereo mode with Link set On.
fig.08-87
Input A
Bass Cut
Bass Cut
Input B
Controlling Channels A and B separately
Setting Link On enables simultaneous control on the 4-Band Parametric Equalizer via Channel B according to the
settings on the Channel A side.
To control Channels A and B separately, turn Link Off.
Parameter (full name)
Link:
Link (Link Switch)
BassCut A/B (Bass Cut Filter): Cuts off undesired low sounds such as pop noise.
Sw (Switch)
Freq (Frequency)
Enhancer:
Sw (Switch)
Mix Level (Mix Level)
Sens (Sense)
Freq (Frequency)
Input:
Gain (Gain)
Detect Time (Detect Time)
Detect Point (Detect Point)
178
Enhancer Input
Enhancer Input
Setting
Channel B follows the settings for Channel A.
On, Off
On, Off
Thru, 20 - 2000 Hz
Accentuates the sound and push the sound forward.
On, Off
-24–+12 dB
0–100
1.0–10.0 kHz
Splits the direct sound into two frequency bands, that is, low and middle
frequency bands.
-24– +12dB
0–10 ms
A, B, Link
Compressor
Expander
Link
Expander
Compressor
Function
Specifies if Channel B follows or does not follow the
settings for Channel A.
Turns the bass cut filter on or off.
Cuts off undesired low frequency band sounds such as pop
noise.
Turns the enhancer on or off.
Sets the amount of the enhancer sound should be mixed
into the direct sound.
Sets the degree of the enhancer effect desired.
Sets the frequency at which the enhancer effect starts working.
Sets the overall volume before entering expander/
compressor.
Sets the length (time) of delay to add to the direct sound input.
Selects the input (Input A/Input B) for controlling Noise
Suppressor. Set this to "Link" for controlling by the input at
a greater level.
Output L
Limiter Output
Limiter Output
Output R