Erasing A Section No Longer Needed (Erase) - Roland VM-C7100 Owner's Manual

Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)

Erasing a section no longer needed (ERASE)

This function is used to erase data in a specified region. It replaces the region from
which data is erased with a space.
fig.11-06_70
FROM/TO
These fields display the region of the data to be erased. The value of REGION SET
(p. 211) indicates the region of the data to be erased.
1. Check if the AUTO MIX VIEW screen is displayed (p. 208).
2. Press CURSOR [DOWN] to move the cursor over to the VIEW/SOURCE/
VALUE TRIM section.
3. Press [F6] (EDITMENU).
The EDIT MENU dialog is displayed. To clear the displayed dialog, press [F6]
(EXIT).
4. Press CURSOR [UP] to move the cursor to the top section in the dialog.
5. Press [F3] (ERASE) to display the ERASE screen.
6. Check FROM/TO to confirm the region of the data to be erased.
To reset the region, reset REGION SET (p. 211).
7. Press CURSOR [DOWN] to move the cursor over to the ERASE section.
8. Press [F4] (EXEC) to execute ERASE.
When ERASE is completed, a "Complete" message will be displayed.
9. Press [F6] (RETURN) and [F6] (EXIT), in this order, to return to the AUTO
MIX VIEW screen.
216
To erase the space created
by erasing data, execute
CUT (p. 217).
Specify the region subject
to editing before
attempting to display the
screen for the erase
operation. Without the
region subject to editing set
up, the screen for the erase
operation cannot be
displayed.
To abort ERASE, press
[EXIT] to return to the
VIEW screen.
Press [UNDO/REDO] to
cancel the erasure just
performed (UNDO).
Pressing [UNDO/REDO]
once more restores the
post-erase state (REDO).