Settings Related To Midi; Settings For Midi Transmission/Reception And Level Meter Bridge (Mb-24); Chapter 12 Using With Midi Devices - Roland VM-C7100 Owner's Manual

Chapter 12 Using with MIDI Devices

Settings Related to MIDI

Settings for MIDI transmission/reception and Level Meter
Bridge (MB-24)
[SHIFT] + [PROJECT]
fig.12-10
1
2
3
4
1
PROGRAM CHANGE
The following settings can be switched using Program Change messages sent from an
external MIDI device. For example, when you want to switch the FX-7 effect algorithm
to a 31-band graphic equalizer, send program number 36 on MIDI channel 7 from an
external MIDI device.
• FX1 to 8 effect algorithm (MIDI channels 1 to 8)
• Master effect's effect algorithm (MIDI channel 9)
• Transport (MIDI channel 13)
• Mute group (MIDI channel 14)
• Locate (MIDI channel 15)
• Scene (MIDI channel 16)
2
Tx PARAM (Transmit parameter)
This should be turned on if you want information describing changes to parameter
settings to be sent to external MIDI devices in the form of System Exclusive messages.
3
DEVICE ID
The device IDs of both devices must be matched before System Exclusive messages
can be transmitted or received between two devices.
4
LEVEL METER SW (Level Meter Bridge switch)
This needs to be set when connecting the Level Meter Bridge (MB-24).
Turn on [F1] (ON) to connect the MIDI device to the console.
Turn on [F2] (ON) to connect the MIDI device to the processor. Turn on both [F2] (ON)
and [F3] (ON) when the devices are cascade connected.
5 Rx PARAM (Receive parameter)
This should be "on" to change the parameter setting following a System Exclusive
message sent from an external MIDI device.
6
MIDI THRU CONSOLE
Determines the use of the MIDI OUT/THRU/METER connector of the console (MIDI
OUT or MIDI THRU). Set this "MIDI OUT" to send MIDI messages to an external
MIDI device; set this "MIDI THRU" to send received MIDI messages directly to other
external MIDI devices.
7
MIDI THRU PROCESSOR
Determines the use of the MIDI OUT/THRU/METER connector of the processor
(MIDI OUT or MIDI THRU). Set this "MIDI OUT" to send MIDI messages to an
external MIDI device; set this "MIDI THRU" to send received MIDI messages directly
to other external MIDI devices.
222
CURSOR [DOWN] [F4] (MIDI)
5
6
7