Others - Roland VM-C7100 Owner's Manual

Others

The volume level of the instrument connected to analog output
jacks/connectors is too low.
Could you be using a connection cable that contains a resistor?
Use a connection cable that does not contain a resistor.
Auto-mixing data have been lost.
Power was turned off before storing the data.
Auto-mixing data is stored in the internal volatile memory. If you turn the
power off before saving a project on a memory card, all the data will be lost.
Data on the main system or memory card has been destroyed.
Power was turned off while reading or writing to the memory.
You must not turn the power off as long as the "Processing" message appears
on the screen.
Adjustment of the input channel pre-amplifier is not possible.
Source of the target input channel is set to "D.IN-L" or "D.IN-R".
The digital input block is not equipped with pre-amplifier (analog circuit).
Turning the input channel phantom power on or off is not
possible.
Source of the target input channel is set to "D.IN-L," "D.IN-R," "CONS-L," or
"CONS-R."
These input channels are not equipped with a phantom power supply.
Settings remain the same even when a scene is recalled.
All the active parameter settings for the scene are turned off.
Unintended sound is generated when the analyzer screen is
turned on.
A number of currently used effects have been assigned to the analyzer in the
course of setting the analyzer setup page FX UNIT FOR ANALYZER.
When the analyzer is currently used, the effects specified above will be
temporarily bypassed.
The waveform does not appear in the ANALYZER.
DISABLE is selected for "FX UNIT FOR ANALYZER" in SETUP.
MAIN EQ page is not operable from ANALYZER screen.
EFFECTS (31 BAND GRAPHIC EQ) is not inserted in MAIN.
FLIP button is inoperable.
[on DISPLAY] button is not set to "ON."
Troubleshooting
263