Space Chorus; Lo-Fi Process (Lo-Fi Processor) - Roland VM-C7100 Owner's Manual

Chapter 8 Using the Internal Effects

Space Chorus

This is a chorus effect simulating Roland SDD-320. The effect to be changed can be reproduced by turning the four
buttons 1 to 4 on or off.
fig.08-51
Input L
Input R
Parameter (full name)
Space Chorus:
Sw (Switch)
Mix Bal (Mix Balance)
Mode (Space Mode)
Input Mode (Input Mode)
Chorus (p. 233)

Lo-Fi Process (Lo-Fi Processor)

This allows you to create a "lo-fi" sound by lowering the sample rate and/or decreasing the number of bits.
fig.08-53
Input L
Input R
Creating lo-fi sounds
Follow the steps below to create lo-fi sounds essential to dance music including hip-hop and DJ music.
Lo-fi Processor
• Turn Pre Filter and Post Filter off. This provides powerful lo-fi sounds containing digital distortion.
• Set Rate and Bit to relatively low values. Note, however, an excessively low value for Bit may cause big
noise even in the silent mode. In that case, increase Threshold (Thresh) of Noise Suppressor.
Realtime Modify Filter
• Increase resonance to add a twist to the sound. Note that excessive resonance may cause oscillation.
154
Output L
Space Chorus
Output R
Setting
Adds a chorus effect simulating SDD-320.
On, Off
0–100
1, 2, 3, 4, 1+4, 2+4, 3+4 Sets the chorus variation style.
Mono, Stereo
Lo-Fi
Processor
Lo-Fi
Processor
Function
Turns the space chorus on or off.
Sets the volume balance between the chorus sound and
the direct sound.
Specifies whether the input signal is stereo or mono.
Realtime
Modify Filter Suppressor
Realtime
Modify Filter Suppressor
Output L
Noise
Noise
Output R