Erasing An Unneeded Portion—Bringing Forward What Follows (Cut) - Roland VM-C7100 Owner's Manual

Erasing an unneeded portion—bringing forward what
follows (CUT)
Use CUT to erase data in a specified region. All data following the region that has
been cut is shifted forward.
fig.11-07_70
FROM/TO
These fields display the data region to be cut. The value of REGION SET (p. 211)
indicates the region of the data to be cut.
1. Check if the AUTO MIX VIEW screen is displayed (p. 208).
2. Press CURSOR [DOWN] to move the cursor over to the VIEW/SOURCE/
VALUE TRIM section.
3. Press [F6] (EDITMENU).
The EDIT MENU dialog is displayed. To clear the displayed dialog, press [F6]
(EXIT).
4. Press CURSOR [UP] to move the cursor to the top section in the dialog.
5. Press [F4] (CUT) to display the CUT screen.
6. Check FROM/TO to confirm the region of the data to be erased.
To reset the region, reset REGION SET (p. 211).
7. Press CURSOR [DOWN] to move the cursor over to the CUT section.
8. Press [F4] (EXEC) to execute CUT.
When CUT is completed, a "Complete" message will be displayed.
9. Press [F6] (RETURN) and [F6] (EXIT), in this order, to return to the AUTO
MIX VIEW screen.
Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)
If you do not want the data
following the region that
has been cut to be shifted
forward, use ERASE (p.
216) instead.
Specify the region subject
to editing before
attempting to display the
screen for the cut
operation. Without the
region subject to editing set
up, the screen for the cut
operation cannot be
displayed.
To abort ERASE, press
[EXIT] to return to the
VIEW screen.
Press [UNDO/REDO] to
cancel the cut just
performed (UNDO).
Pressing [UNDO/REDO]
once more restores the
post-cut state (REDO).
217