Loop And Auto Punch In/Out - Roland VM-C7100 Owner's Manual

Loop and auto punch in/out

Using the Loop Function, you can control connected recorders remotely so that it
automatically repeats "Play
This function also allows automatic execution of Punch In and Punch Out to be
turned on during recording. As long as this operation continues, the system
continuously sends play
running external recorder at a predetermined timing.
Specifying loop and punch in/out point
1. While holding down [SHIFT], press [LOCATE] (EDIT).
2. Press [PAGE DOWN] (SETUP) and CURSOR [UP], in that order.
The setup screen appears, allowing you to select the loop option.
fig.10-007
3. Specify the loop start/end points.
Using the V3 knob (START) and the V5 knob (END), enter the desired time in each
column.
You can move through the columns using CURSOR [LEFT] and [RIGHT] while
holding down [SHIFT].
4. Using the V2 knob (REPEAT), specify the repeat count (1 to 100).
5. Press CURSOR [DOWN] to select the punch in/out option.
6. Select punch in/out points.
Using the V3 knob (IN) and the V5 knob (OUT), enter the desired time in the
respective column.
Turning loop and punch in/out on or off
In the above setup screen, you can turn loop and punch in/out on or off by pressing
[F1] (ON) from the respective cursor positions.
Using these panel buttons, you can turn the above on or off from another screen.
While holding down [SHIFT], press [ZERO] (LOOP) to turn the loop on or off.
While holding down [SHIFT], press [COPY/LIBRARY] (AUTO PUNCH) to turn
auto punch in/out on or off.
Rewind" for a specified region.
record play switching information to a currently
Chapter 10 Combining Recorders
Press [F3] and [F5] (NOW)
to set the current time at
the respective points.
195