If You Get Lost; Preparing A Memory Card - Roland VM-C7100 Owner's Manual

Chapter 1 Introduction

If you get lost

If an unfamiliar screen appears, or you forget to which step you have proceeded,
press [LEVEL METER]. This calls the initial screen. Try again from the beginning on
this screen.
fig.01-18

Preparing a memory card

Before any operation, be sure to create a new project on the memory card. If no
project is prepared beforehand, scenes, Automix or libraries are not stored. Before
using a new memory card or one that has already been used for other purposes, be
sure to format it.
Formatting a memory card
1. While holding down [SHIFT], press [PROJECT].
2. Press CURSOR [DOWN] to move the cursor downward.
3. Press [F6] (MEMORY CARD) and [F2] (FORMAT), in that order.
4. Press [F5] (OK).
5. After the confirmation message appears, press [F5] again.
6. After formatting is completed, press [F6] (EXIT).
Creating new project
1. Press [PROJECT].
2. Press CURSOR [DOWN] to move the cursor downward.
3. Press [F2] (NEW).
4. Press [F2] (CREATE), followed by [F5] (OK).
5. After creation is completed, press [F6] (EXIT).
28