Controlling A Midi Device From The Console - Roland VM-C7100 Owner's Manual

Chapter 12 Using with MIDI Devices

Controlling a MIDI device from the console

fig.12-03*
Controlling volume or panning
Change to the following screen by pressing [MULTI OUT] while holding [SHIFT]
down. Control Change messages are transmitted to an external device when you
operate the fader or knobs on this screen. This allows you to control the volume of the
connected MIDI device (LEVEL: Controller Number 7) or panning (PAN: Controller
Number 10).
fig.12-05
Press [F1] to [F6] to turn off the channels which do not transmit Control Change
messages.
228
The processor also has a
MIDI OUT/THRU/
METER connector which is
used in the same way as
that on the console. When
the external MIDI device
has been connected to the
processor, set MIDI THRU
PROCESSOR to "OUT" on
the SYSTEM MIDI screen.
When the MB-24 (Level
Meter Bridge) is used,
connect between the MIDI
OUT/THRU connector of
the MB-24 and the MIDI IN
connector of the external
MIDI device.
Continued...