To Instantaneously Lower The Monitoring Volume (Dim); Setting The Monitor Stereo Balance; Monitoring In Mono - Roland VM-C7100 Owner's Manual

To instantaneously lower the monitoring volume (DIM)

Press [DIM] to instantly lower the monitor volume to a pre-set level. Press the button
again to turn dimming off and return the monitoring volume to its normal level.
Pre-setting the dim level
1. Press MONITOR/PHONES [SOURCE SELECT] while holding down
[SHIFT].
This calls up the monitor screen.
2. Use CURSOR [UP] to select DIM/BALANCE/MONO.
fig.06-27
3. Use the V1 (DIM LEVEL) knob to set the level to which monitoring will
drop when dimming is activated.
With a setting of 100, dimming will leave the listening volume as is. Select a lower
number to cause the volume to be reduced when dimming is engaged. Dimming can
also be turned on or off by pressing [F1] (DIM).

Setting the monitor stereo balance

You can set the stereo left/right balance of the monitor signal.
Setting the monitor stereo balance
1. Press MONITOR/PHONES [SOURCE SELECT] while holding down
[SHIFT].
This calls up the monitor screen.
2. Use CURSOR [UP] to select DIM/BALANCE/MONO in the top section of
the display.
3. Set the monitor stereo balance using the V2 knob (BAL).
The stereo balance can be set from L63 to C to R63. A setting of L63 or R63 silences
the signal in the opposing channel.

Monitoring in mono

There are times when it can be useful to monitor in mono. Press [F2] (MONO) in Step
2 in "Setting the monitor stereo balance" above to mix the left and right sides of the
monitor signal equally into a single monaural signal.
Chapter 6 Mixing Procedure 2 (Output and Monitor)
99