Guitarampsim (Guitar Amplifier Simulator) - Roland VM-C7100 Owner's Manual

Chapter 8 Using the Internal Effects
Rotary
Simulates a rotary speaker. Behaviors of high and low frequency band Roters can be set up separately, allowing
realistic modeling of unique surging sensation. This effect is suited for organ sounds.
fig.08-32
Input L
Input R
Parameter (full name)
Noise Suppressor:
Sw (Switch)
Thresh (Threshold)
Release (Release)
Overdrive:
Sw (Switch)
Output Level (Level)
Gain (Gain)
Rotary Speaker:
Lo-Rate (Low Rate)
Hi-Rate (High Rate)
Noise Suppressor (p. 240), Overdrive (p. 241), Rotary (p. 244)

GuitarAmpSim (Guitar Amplifier Simulator)

Simulates a guitar amplifier.
fig.08-34
Input L
Input R
138
Noise Suppressor
Setting
Mutes noise in the silent mode.
On, Off
0–100
0–100
Adds distortion to the sound.
On, Off
0–100
0–100
Simulates a rotary speaker.
0.1–10.0 Hz
0.1–10.0 Hz
Noise Suppressor
Over Drive Rotary Speaker
Function
Turns the noise suppressor on or off.
Sets the level to start muting noise.
Sets the time over which the volume will drop to 0 after the
noise starts being muted.
Turns overdrive on or off.
Sets the volume of the overdrive sound.
Sets the degree of sound distortion.
Sets the rotary frequency of the low frequency band roter.
Sets the rotary frequency of the high frequency band roter.
G-Amp Speaker Simulator
Output L
Output R
Output L
Output R