Disconnecting Backup Power; Turning The Power On And Off; Turning The Power On; Turning The Power Off - Roland M-5000 Reference Manual

Placement and Setup

Disconnecting Backup Power

Follow the steps below to disconnect the external power unit.
1.
While keeping the lock switch on the adapter cable
(XLR4 end) connected to the S-240P depressed, detach
the cable from the EXT. POWER DC INPUT connector.
2.
While holding the lock switch on the S-240P's DC OUTPUT
plug pulled back, twist counterclockwise.
3.
Detach the DC OUTPUT plug on the S-240P from the
adapter cable (Speakon end).
20

Turning the Power On and Off

* Before turning the unit on/off, always be sure to turn the levels
down as well as turning off any amps or powered speakers. Even
with the volume turned down, you might hear some sound
when switching the unit on/off. However, this is normal and
does not indicate a malfunction.

Turning the Power On

* Once everything is properly connected be sure to follow the
procedure below to turn on the power. If you turn on equipment
in the wrong order, you risk causing malfunction or equipment
failure.
1.
Turn on the power to any equipment connected to audio
inputs on the M-5000 or on any input/output units (S-
2416, S-4000S, or the like) connected to the M-5000.
* Acoustic feedback could be produced depending on the
location of microphones relative to speakers. This can be
remedied by:
5 Changing the orientation of the microphone(s).
5 Relocating microphone(s) at a greater distance from speakers.
5 Lowering volume levels.
2.
Turn on the [POWER] switch on the M-5000.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after turning the unit on is required before it will
operate normally.
* When restarting the unit with the expansion interface installed,
wait for about one second before you turn on the power.
3.
Turn on the power to the external power unit connected
to the EXT. POWER DC INPUT connector on the M-5000.
4.
Turn on the power to the input/output units.
5.
Turn on the power to any equipment connected to audio
output on the M-5000 or on any input/output units.

Turning the Power Off

1.
Go to the MUTE GROUP MASTER window and tap <MUTE
ALL OUTPUTS> to mute audio output on the M-5000 and
on any input/output units (S-2416, S-4000, or the like)
connected to the M-5000.
0 "Muting All Outputs" (p. 61)
2.
Turn down the output and turn off the power to any
equipment connected to audio output on the M-5000 or
on any input/output units.
3.
Turn off the power to the external power unit connected
to the EXT. POWER DC INPUT connector on the M-5000.
* If an external power Unit is providing power to the M-5000, the
M-5000 will keep operating even if the power switch is in the
OFF position.
4.
Turn off the [POWER] switch on the M-5000.
5.
Turn off the power to the input/output units.
6.
Turn off the power to any equipment connected to audio
input on the M-5000 or on any input/output units.
* To prevent malfunction and equipment failure, always turn
down the volume, and turn off all the units before making any
connections.