Simultaneously Setting Several Channels' Parameters (Parameter View On Fader) - Roland VM-C7100 Owner's Manual

Chapter 4 Useful Functions
Simultaneously Setting Several Channels'
Parameters (Parameter View on Fader)
When parameters such as levels, pans and the amount of signal sent to the Flex Buses
are to be set, these parameters' values for all channels can be displayed at the same
time. This display is called the "parameter view on fader." This view is helpful when
the parameter settings of multiple channels need to be adjusted at the same time.
Operation of [PARAM VIEW on Fader]
fig.04-09
Allows you to view parameter settings for all channels simultaneously, controlling
their value primarily by using the console's channel faders.
Determining a parameter setting to change
Press any of the numbered buttons under [PARM VIEW on Fader] to view its
corresponding parameter in the currently selected parameter section. Since the types
of parameters differ in each section, the screen may not change when a numbered
button is pressed.
fig.04-10e
Parameter Setting under PARAM VIEW on Fader
SECTION
(Signal Line)
INPUT
MULTI IN
FADER GROUP
FLEX BUS 1–12
MIDI
MULTI OUT
[OTHER PARAMETERS A]/[OTHER PARAMETERS B]
Sets the equalizer or delay.
To select a parameter, move the cursor to the bottom of the screen, turn the [V1] knob
to select the target parameter and press [F1] (SET).
64
CH CH CUE
LEV PAN LEV
YES YES YES
YES YES YES
YES --- ---
YES YES YES
YES YES
---
YES --- ---
SURROUND
CUE PREAMP
DEPTH
PAN GAIN
YES YES YES
YES --- YES
--- --- ---
YES --- YES
--- --- ---
--- --- ---
OTHER
FLEX BUS
send to 1–12 PARAMETERS
YES YES
YES YES
--- ---
YES YES
--- YES
--- ---