Specifying A Point By Direct Entry Of Time - Roland VM-C7100 Owner's Manual

Chapter 10 Combining Recorders
2. Select a location number to be edited.
You can select the number using the V1 knob (SELECT NUMBER). If you press [F1]
(RECALL) at this time, the number will be located at the registered time.
3. Changing registered contents.
[F4] (CLEAR)
[F5] (REGIST)
V2 knob (TIME)
V4 knob (PRE ROLL)
[F6] (PROTECT)

Specifying a point by direct entry of time

You can advance or return the time set on a remote controlled recorder or Automix
by the hour, minute, second or frame from the numerical keypad (Time Code Locate
function).
Locating by entering time code
1. While holding down [SHIFT], press [ENTER] (TC LOCATE).
The [TIME CODE LOCATE] screen appears.
fig.10-006
2. Using numerical keys [0] to [9], specify the hour, minute, second and frame.
Specify the time as an 8-digit number. For example, when specifying "00 hours, 31
minutes, 08 seconds, 21 frames," enter [0][0][3][1][0][8][2][1] from the numerical
keypad.
3. Press [ENTER].
The time set on every device will be moved to the specified point.
194
Used to Clear registered contents.
Used to register Current Time.
Used to correct current settings on a column basis.
(You can move through columns using CURSOR
[LEFT] and [RIGHT] while holding down [SHIFT].)
Used to specify a Pre-roll time.
Pre-roll denotes the function used for rewinding a tape
slightly further than the specified time. When this
function is turned on, the current time will be moved
forward of the time of the recalled locate point (within
0 to 10.0 seconds).
Used to turn on Protect for a locate point.
If you turn on (Protect),
option "P" is checked on
the list.
You cannot specify a pre-
roll time (see above) when
the Time Code Locate
function is selected.
Press [F6] (CANCEL) to
cancel the operation.
The time entered does not
include an offset (SYNC
OFFSET) to be set from the
system SYNC CLOCK
(MMC) screen. The above
time is commonly
applicable to external
equipment. Thus, if an
offset is specified, there can
be an inconsistency
between the specified time
and the resulting locate
point.