Setting Input/Output Levels; Selecting The Effect Library - Roland VM-C7100 Owner's Manual

Setting input/output levels

In the Assign Effect page, you can specify the input level for each effect unit and
output levels from the effects.
The levels are set with the V4 (SEND LEVEL) and V5 (RETURN LEVEL) knobs after
selecting L or R with CURSOR [UP] and [DOWN]. (For the master effect, use the V3
and V4 knobs. The setting range is 0 to 127; a value of 100 provides no increase/
decrease (0 dB).
fig.08-004

Selecting the effect library

A selection of 200 preset libraries (P000 to P199) are provided for the effects. You
can select a library that suits your purpose, and copy it to an effect from 1 through 8
or the master effect.
Selecting a library
1. Invoke the Effect screen menu.
For effects 1 to 8, press [EFFECTS 1-8], or for the master effect, press [SP MODELING
(MASTER FX)].
fig.08-002
2. Select effect column to use with CURSOR [UP] and [DOWN].
The effects appear on the screen in the following order from top to bottom: 1 to 3, 4
to 6, and 7 to 8.
(This step is not required for the master effect.)
Chapter 8 Using the Internal Effects
Although the screen
display reads "SEND
LEVEL" and "RETURN
LEVEL," you can use this
page to set the input/
output levels when effects
are used in the insert.
(Whether or not FBUS
SEND/RTN (INT) has been
chosen for the position is
irrelevant to this setting.)
113