Internal Signal Flow - Roland VM-C7100 Owner's Manual

Internal Signal Flow

The diagram below provides an overview of the audio signal flow. For details, refer
to the "Block Diagram" attached to the processor (VM-7200/7100).
fig.01-9e
INPUT
Phase
ATT
normal/invert
Analog Input
Digital Input A, B
(R-BUS Input)
Patchbay
Flex Bus 1–12
From Flex Bus 1–8 to Cue and Flex Bus 1–12
Input channels
INPUT...1–24
The following input jacks can be assigned to input channels:
• Twenty analog input jacks on the VM-7200 mixing processor (10 on VM-
7100)
• Stereo digital IN on the mixing processor (a choice of A and B stereo inputs)
• Two analog input jacks on the console
MULTI IN...1–24
Multi-channel audio signals can be input from external equipment—such as multi-
track recorders—via these channels. The correspondence between input signal
channel numbers and MULTI IN channels can be re-patched internally.
* In order to use MULTI IN channels, a VM-24E (sold separately) must be
connected to the mixing processor in order to add an R-BUS connector I/O
terminal.
Effect
Insert
Phase Feedback
HPF
Delay Delay
Effect
Insert
4-band Channel
Mute
EQ Level
Input Cannel 1–24
(Multi In Channel 1–24)
Flex Bus Out 5–12 **
* This is not available for the MULTI IN channel.
** Only VM-7200
Chapter 1 Introduction
to Main Out Bus
Main
Pan
SW
to Cue and Flex Bus
Main Out L, R
Cue L, R
Assignable Out
Digital Out A, B
Multi Out (R-BUS) *
Monitor Out **
29