Switching The Status Of A Channel; Muting A Channel (Mute) - Roland VM-C7100 Owner's Manual

Switching the Status of a Channel

The STATUS button above each fader switches the status of the corresponding input
channel. The STATUS button can change the following four items:
Mute:
Solo:
Audio:
Auto-mix:
Press the MODE buttons in the CH STATUS area—[MUTE], [SOLO], [AUDIO] or
[AUTO-MIX]—to select the item you want to set using the STATUS button.
fig.05-16
This section describes the operation of the MUTE and SOLO buttons.

Muting a channel (MUTE)

Signals on input channels—both input and multi-in channels—can be muted using
the STATUS button.
Muting with the STATUS button
1. Press the [MUTE] in the CH STATUS MODE area—the button will light
when muting is activated.
2. Select either [INPUT] or [MULTI IN], depending on the type of channel
you want to mute.
3. Press the desired channel's STATUS button so that it lights.
Any channels selected with SECTION buttons can be muted using the same
procedure, including [FADER GROUP] (Group 1–24), [FLEX BUS] (Flex Buses 1 –12)
and [MULTI OUT] (Multi Out 1–24).
fig.05-17
Call up the screen by pressing the MAIN/CUE STATUS button while holding down
the desired channel's [CH EDIT]. To mute the channel, press [F6] (MUTE)—the
channel's MUTE indicator in the displayed graph will be shown as a reversed image.
Chapter 5 Mixing Procedure 1 (Input Channel)
When on, silences the channel's signal.
When on, isolates the channel's signal, silencing other
channels.
Switches the track status of connected external recording
devices.
Activates or de-activates automation recording of channel-
setting changes.
Audio Status (p. 192)
Auto-mix Status (p. 201)
Muting signals on input
and multi-in channels
causes all of their signals to
be muted, including those
sent to Flex Buses and cue
busses, unless their send
points are set to Pre EQ.
(For details, see the
attached block diagram
with the processor.)
If you wish, you can also
switch the MUTE function
on or off from the VIEW
page on the MUTE GROUP
SETUP screen (p. 103). You
can also mute a channel by
setting MUTE on CH
EDIT's MAIN/CUE page.
77