B: Monitor area
fig.01-3
1
2
3
1...SOURCE/STUDIO2 button
Calls up a screen for selecting the source of the STUDIO 1/2 output that typically
feeds studio or stage monitors. Since no knob is provided for STUDIO 2, its level is
also adjusted from the screen.
* The STUDIO 1 and 2 outputs are monitor signals intended for performers in a
studio or on a stage. The STUDIO 1 signals are output in stereo to
ASSIGNABLE OUTs 1 and 2 of the mixing processor, while STUDIO 2's stereo
signal is sent to ASSIGNABLE OUTs 3 and 4.
2...STUDIO 1 LEVEL knob
Adjusts the level of the STUDIO 1 outputs. (Since the same setting can be changed
using a V knob when the source select screen of STUDIO 1 is displayed, the physical
position of this knob may differ from the actual STUDIO 1 setting.)
3...DIGITAL (MASTER) level knob
Master knob for changing the level of signals to be sent to the CONTROL ROOM
monitor output of the console. When this knob is moved, the volume of audio
transmitted via the DIGITAL OUT is also changed.
4...LINE OUT LEVEL knob
Level knob (analog volume) for the LINE OUT jacks on the rear of the console.
5...PHONES LEVEL knob
Volume knob for headphones connected to the PHONES 1 and/or 2 jacks. The
volume of the two headphone jacks cannot be adjusted independently.
6...MIC LEVEL knob
Knob for adjusting the level of the talkback system. The knob also functions as a gain
control for any connected talkback microphone.
5
4
15
14
13
7
8
6
12
11
Chapter 1 Introduction
9
10
13