Settings (Data Types) That Can Be Recorded/Played Back - Roland VM-C7100 Owner's Manual

Chapter 11 Recording/Playing Back Fader or Knob Actions (Automix)

Settings (data types) that can be recorded/played back

The respective settings composing Automix are referred to as "data." With the
Automix function, the following types of data can be recorded by using the faders or
operating devices like the [V1] to [V6] knobs. Note that data types that can be
recorded vary from section to section.
Data that can be recorded in INPUT/MULTI IN
Equalizer (settings for Equalizer)
- HPF ON/OFF (switch): On/off settings for the high pass filter
- HPF FREQ:
- EQ ON/OFF (switch): On/off settings for the equalizer
- EQ HI GAIN:
- EQ HI FREQ:
- EQ HI-MID GAIN:
- EQ HI-MID FREQ:
- EQ HI-MID Q:
- EQ LO-MID TYPE:
- EQ LO-MID GAIN:
- EQ LO-MID FREQ:
- EQ LO-MID Q:
- EQ LO-MID RESO:
- EQ LO GAIN:
- EQ LO FREQ:
Flex buses 1–12 (settings of signals to be sent to flex buses 1 to 12)
- Switch:
- SEND LEVEL:
- PAN:
Surround (setting for the sound field)
- PAN:
- DEPTH:
- LR:C RATIO:
CUE SEND (setting of signals sent to the cue bus)
- Switch:
- LEVEL:
- PAN:
MAIN SEND (setting of signals sent to the main bus)
- Switch:
- LEVEL:
- PAN:
Other data types
- ø (phase switch):
- Mute switch:
Data that can be recorded with FLEX BUS MASTER 1 - 8
Flex buses 1 - 12 (settings of signals to be sent to flex buses 1 to 12)
- Switch:
- SEND LEVEL:
- PAN:
Surround (setting for the sound field)
- PAN:
- DEPTH:
- LR:C RATIO:
198
The frequency at which the high pass filter starts operating
Amount of boost/cut in the high frequency band
The central frequency in the high frequency band
Amount of boost/cut in the high-to-middle frequency band
The central frequency in the high-to-middle frequency band
The bandwidth of the high-to-middle frequency band
Filter type for the low-to-middle frequency band
Amount of boost/cut in the low-to-middle frequency band
The central frequency in the low-to-middle frequency band
The bandwidth of the low-to-middle frequency band
Resonance in the low-to-middle frequency band
Amount of boost/cut in the low frequency band
The central frequency in the low frequency band
Sends/does not send signals.
Level
Panning
Sound localization (right/left)
Sound localization (front/rear)
Level ratio of the speakers (right/left: center)
Sends/does not send signals.
Level
Panning
Sends/does not send signals.
Level
Panning
Inverts/does not invert input signals.
Mutes/does not mute the channel.
Sends/does not send signals.
Level
Panning
Sound localization (right/left)
Sound localization (front/rear)
Level ratio of the speakers (right/left: center)
PAN for flex buses can only
be set for linked buses.
PAN for a flex bus can only
be set for the linked bus.