Roland VM-C7100 Owner's Manual page 166

Parameter (full name)
Link:
Link (Link Switch)
Mic Converter A/B:
Sw (Switch)
Input (Input)
Output (Output)
Phase (Phase)
BassCut A/ (Bass Cut Filter): Cuts off undesired low frequency band sounds such as pop noise.
Sw (Switch)
Freq (Frequency)
Distance A/B:
Sw (Switch)
Prox-Efect (Proximity Effect)
Time (Time)
Limiter A/B:
Sw (Switch)
Thresh (Threshold)
Attack (Attack Time)
Release (Release Time)
Detect HPF (Detect HPF Frequency)
Output Level (Output Level)
Microphone Converter (p. 239), Bass Cut Filter (p. 233), Distance (p. 235), Limiter (p. 238)
Setting
Channel B follows the settings for Channel A.
On, Off
Converts the characteristics of the low-end general-purpose microphone into
the characteristics of the high-end microphone for studio application.
On, Off
See the column on
the previous page.
See the column on
the previous page.
Norm, Inv
On, Off
Thru, 20 - 2000 Hz
Simulates the frequency characteristics and time difference due to distance
difference.
On, Off
-12– +12
0–3000 cm
Prevents distortion by suppressing signals at high levels.
On, Off
-60–0 dB
0–100
0–100
Thru, 20 - 2000 Hz
-60– +12 dB
Chapter 8 Using the Internal Effects
Function
Specifies if Channel B follows or does not follow the
settings for Channel A.
Turns the microphone converter on or off.
Sets the microphone type used for recording.
Sets the microphone types to be simulated.
Sets the microphone phase.
Turns the bass cut filter on or off.
Sets the frequency for cutting off undesired low frequency
band sounds such as pop noise.
Turns the distance on or off.
Corrects the low frequency band characteristics due to the
distance from the sound source.
Simulates the time difference due to the distance from the
sound source.
Turns the limiter on or off.
Sets the volume level to start suppressing excessive input.
Sets the time from when the input level exceeds the
threshold level to when the effect begins to apply.
Sets the time from when the input level drops below the
threshold level to when the effect ceases to apply.
Normally, sets "Thru".
Sets the cutoff frequency of the level detection section.
Sets the volume of the compressor sound.
165