Äremotely Controlling A Ptz Camera; Network Settings On The Camera; Registering Camera Settings In A Preset - Roland VR-6HD Reference Manual

Other Functions
Remotely Controlling a PTZ Camera
You can connect up to six cameras via the DIRECT STREAM port and remotely control them from the VR-6HD.
This allows you to control cameras made by JVC, Panasonic, Canon, PTZOptics, and Avonic, and cameras that support VISCA over IP (such as Sony).
* Refer also to the owner's manual of your camera.

Network Settings on the Camera

In order to control a camera from the VR-6HD, you need to make network
settings on the camera. You can register up to six cameras.
1 .
Follow the steps in "Using the dashboard" (p. 84) to assign
the "CAMERA CONTROL" function to a USER button on the
dashboard.
Network settings for the camera
Ó
2 .
[MENU] button "REMOTE"
and press the [VALUE] knob.
This shows the camera control.
3 .
Touch <SETUP>.
CAMERA ID
The setup screen appears.
4 .
Touch the screen to configure the camera's network settings.
Menu item Explanation
CAMERA ID Selects the camera to be controlled.
PROTOCOL Specifies the camera's protocol.
IP ADDRESS Input the camera's IP address.
When "PROTOCOL" is "JVC"
Touch <Login Name> to bring up the software
LOGIN NAME
keyboard for input, and enter the login name
needed to connect with the camera.
When "PROTOCOL" is "JVC"
Touch <Password> to bring up the software
PASSWORD
keyboard for input, and enter the password needed
to connect with the camera.
5 .
Press the [EXIT] button to close the setup screen.
86
Ó
select "CAMERA CONTROL",

Registering Camera Settings in a Preset

Up to 6 sets of settings such as camera position and focus can be
registered as presets.
A registered preset can be recalled when needed.
* Presets are saved in the camera itself.
1 .
In step 2 of "Network Settings on the Camera" (p. 86),
bring up the camera control screen.
2 .
Touch the screen to operate the camera settings.
Menu item Explanation
Adjusts the horizontal/ vertical
position.
POSITIONER
Drag on the screen to operate
the camera.
Adjusts the speed at which the camera changes
SPEED
direction.
PROTOCOL Specifies the camera's protocol.
ZOOM Adjusts the zoom position. (*1)
FOCUS Adjusts the focal point. (*1)
When this is "ON", the focal point is set
AUTO FOCUS
automatically.
EXPOSURE Specifies the exposure mode.
Specifies the connector from which the camera
video is input.
TALLY CH
When the camera video from the VR-6HD is the final
output, the camera's tally light is lit.
(*1) You can operate the camera while touching the screen.
3 .
Touch the arrows in the page switching area to show page 2.
4 .
Touch <STORE>.
5 .
Touch the preset number (CAMERA PRESET 1–6) area where
you want to register the settings.
A confirmation message appears.
* If you decide to cancel, press the [EXIT] button.
6 .
Use the [VALUE] knob to select "OK", and then press the
[VALUE] knob.
The camera settings are registered in the preset.
7 .
Press the [MENU] button to close the menu.