Data Type - Mitsubishi Electric M80V Series Manual

M800V/M80V Series PLC Interface Manual
5 Appx.1: PLC window

5.3 Data Type

5.3 Data Type
Data Type
This is position data, and is input and output in the minimum set-
ting unit which is specified by the machine parameter. This data
is not changed by the initial inch parameter or constant inch input
PLC setting unit
(M_inch) parameter.
However, this data may change depending on the PLC setting
unit.
This is speed data, and is input and output at the minimum setting
unit/min. This data is not changed by the initial inch parameter or
PLC setting unit/
constant inch input (M_inch) parameter.
min.
However, this data may change depending on the PLC setting
unit.
Machine error
The unit of this data is one half of the NC control unit. The control
compensation
unit depends on the specification.
unit
This is real number type data in a unit other than the above or
without a unit.
The input/output specification of the decimal point data for the
PLC window can be selected with "#1259 set31/bit2" (Disabling
decimal point for PLC window).
Fixed point 0: Enable decimal point
Fraction data is output as the fixed fraction information.
(The numbers of digits in the integer and fraction parts are the
same as of the on-screen specifications.)
1: Disable decimal point (cut off all digits after decimal point)
Only the integer part is input/output.
This is data in a unit other than the above types or the data with-
Integer
out a unit.
This is character string data. Up to two characters can be input
Character string
and output.
Description
709
Unit (when the control unit and minimum setting
unit are 1μm)
μm
μm/min
0.5 µm
Unit specific to data
This data is not changed by the control unit or minimum
setting unit.
-
-
IB-1501616-D