Mitsubishi Electric M80V Series Manual page 611

M800V/M80V Series PLC Interface Manual
4 Explanation of Interface Signals
4.4 PLC Output Signals (Data Type: R***)
Cont. Signal name
A Speed override valid
[Function] [Operation]
This is a signal to validate the speed override. When this signal is turned OFF, the set feedrate becomes the operation
speed without calculating the override.
Signal name
PLC axis indexing control command 3
Cont. Signal name
A Station selection 1 to 256
[Function]
This signal designates an index station No. in the automatic operation mode.
[Operation]
Set an index station No. before inputting the "Operation start" (ST) in the automatic operation mode.
Input a 9-digit binary number. An input "000000001" corresponds to station No.1.
This signal is read in at the rising edge of the "Operation start" (ST). The signal changes are ignored after the startup.
When this signal is set to "000000000" and the automatic operation is started, a one-station rotation special command is
issued. (Note that this cannot be used when the station positions are determined in non-uniform assignments.)
Signal name
PLC axis indexing control command 2
IB-1501616-D
Abbrev.
OVR
Abbrev. 1st axis 2nd axis 3rd axis 4th axis 5th axis 6th axis 7th axis 8th axis
AUXCM3 R8051 R8057
Abbrev.
ST1 to
ST256
Abbrev. 1st axis 2nd axis 3rd axis 4th axis 5th axis 6th axis 7th axis 8th axis
AUXCM2 R8052 R8058
598
bit
AUXCM4/bit7
R8063 R8069 R8075 R8081
bit
AUXCM3/bit0 to 8
R8064 R8070 R8076 R8082
R8087 R8093
R8088 R8094