Mitsubishi Electric M80V Series Manual page 464

M800V/M80V Series PLC Interface Manual
4 Explanation of Interface Signals
4.3 PLC Output Signals (Bit Type: Y***)
Cont. Signal name
Handle/incremental feed magnification
A
method selection
[Function]
This signal is a signal to switch whether the movement magnification for the basic movement amount of handle feed and
incremental feed is performed by the "code method" and the "file register method".
[Operation]
When the "Handle/incremental feed magnification method selection" signal (MPS) is OFF, the MP1, MP2, MP4 code
method is selected.
When the "Handle/incremental feed magnification method selection" signal (MPS) is ON, the file register magnification
method is selected.
Basic amount of feed
×
(1μm)
Note
(1) For details of the code method and the file register method, refer to the relevant descriptions.
[Related signals]
(1) Handle/Incremental feed magnification code m (MP1, MP2, MP4: YC80, YC81, YC82)
(2) 1st handle/incremental feed magnification (R2508, R2509)
Cont. Signal name
A Tool alarm 1/Tool-skip
[Function]
This signal sets the spindle tool status during tool life management to status 3 (Tool alarm 1/Tool skip).
[Operation]
By turning ON the signal in the tool life management specification, the tool status of a spindle tool can be changed to "3".
When the tool life is managed for each tool group, the tool status of a tool selected when a tool group No. is designated
can be changed to "3".
However, the "Tool life management input" signal (YC8B) needs to be turned ON to enable this function.
Cont. Signal name
A Tool alarm 2
[Function]
This signal sets the tool data status during tool life management to status 4 (Tool alarm 2).
[Operation]
By turning ON the signal in the tool life management specification, the tool status of a spindle tool can be changed to "4".
When the tool life is managed for each tool group, the tool status of a tool selected when a tool group No. is designated
can be changed to "4".
However, the "Tool life management input" signal (YC8B) needs to be turned ON to enable this function.
Cont. Signal name
A Usage data count valid
[Function]
This signal enables tool life count during the tool life management.
[Operation]
For the tool life management specifications, the tool life count (usage time or usage count corresponding to tool) is
enabled.
However, the "Tool life management input" signal (YC8B) needs to be turned ON to enable this function.
Abbrev. $1
MPS YC87
MPS
OFF: Code method
Multiplier by MP1, MP2, MP4
Multiplier by value set in file register
ON: File register method
Abbrev. $1
TAL1 YC88
Abbrev. $1
TAL2 YC89
Abbrev. $1
TCEF YC8A
$2 $3 $4
YDC7 YF07 Y1047 Y1187
$2 $3 $4
YDC8 YF08 Y1048 Y1188
$2 $3 $4
YDC9 YF09 Y1049 Y1189
$2 $3 $4
YDCA YF0A Y104A Y118A
451
$5 $6 $7 $8
Y12C7 Y1407 Y1547
=
True amount
of motion
$5 $6 $7 $8
Y12C8 Y1408 Y1548
$5 $6 $7 $8
Y12C9 Y1409 Y1549
$5 $6 $7 $8
Y12CA Y140A Y154A
IB-1501616-D