Mitsubishi Electric M80V Series Manual page 229

M800V/M80V Series PLC Interface Manual
4 Explanation of Interface Signals
4.1 PLC Input Signals (Bit Type: X***)
Cont. Signal name
A In circular feed in manual mode
[Function]
This signal indicates that the circular feed in manual mode is valid.
[Operation]
This signal turns ON when the "Circular feed in manual mode valid" signal turns ON.
[Caution]
This signal does not turn ON in the following conditions.
 Either H axis or V axis is in machine lock. (In this case, even machine lock is not performed.)
 The reference position return of either H axis or V axis is not completed.
 Either H axis or V axis is in servo OFF.
 Either H axis or V axis detached.
 The NC is in one of the following states.
- In automatic operation (OP)
- Emergency stop
- Reset
 The current position is outside of the specified movable range.
 The setting value which is specified with R register is illegal.
[Related signals]
(1) Circular feed in manual mode valid (YC7E)
(2) Circular feed in manual mode Operation mode data (R2636,7)
(3) Circular feed in manual mode Reference point H data (R2644,5)
(4) Circular feed in manual mode Reference point V data (R2648,9)
(5) Circular feed in manual mode Gradient/arc center H data (R2668,9)
(6) Circular feed in manual mode Gradient/arc center V data (R2672,3)
(7) Circular feed in manual mode Travel range H (+) data (R2652,3)
(8) Circular feed in manual mode Travel range H (-) data (R2656,7)
(9) Circular feed in manual mode Travel range V (+) data (R2660,1)
(10) Circular feed in manual mode Travel range V (-) data (R2664,5)
(11) Circular feed in manual mode Current position H (R636,7)
(12) Circular feed in manual mode Current position V (R640,1)
IB-1501616-D
Abbrev. $1 $2
XC4F XD8F XECF
216
$3 $4 $5 $6
X100F X114F X128F
$7 $8
X13CF X150F