Mitsubishi Electric M80V Series Manual page 181

M800V/M80V Series PLC Interface Manual
4 Explanation of Interface Signals
4.1 PLC Input Signals (Bit Type: X***)
Cont. Signal name
High-speed simple program check: Coordinate position
A
[Function]
This signal informs that the coordinate position check is enabled during the high-speed simple program check.
[Operation]
This signal turns ON when the "High-speed simple program check: Enable coordinate position check" signal (Y76B) is
ON.
This signal turns OFF when the "High-speed simple program check: Enable coordinate position check" signal (Y76B) is
OFF.
[Related signals]
(1) High-speed simple program check mode (SMLK: Y73E)
(2) High-speed simple program check mode ON (SMLKO: X712)
(3) High-speed simple program check: Enable coordinate position check (SPSC: Y76B)
Cont. Signal name
A Manual arbitrary reverse run: Actual cutting mode ON
[Function]
When the parameter "#1260 set32/bit0" (Switching to actual cutting mode during automatic operation) is set to "1", this
signal indicates that the actual cutting mode in manual arbitrary reverse run is valid.
When the parameter "#1260 set32/bit0" is set to "0", this signal does not turn ON/OFF.
[Operation]
This signal turns ON when:
 Except for the specific movement block during thread cutting, thread cutting cycle and tapping cycle, the "Manual arbi-
trary reverse run mode ON" (X715) is turned ON and the "Actual cutting mode (thread, tap) in manual arbitrary reverse
run" (Y761) is turned ON.
This signal turns OFF when:
 Except for the specific movement block during thread cutting, thread cutting cycle and tapping cycle, the "Manual arbi-
trary reverse run mode ON" (X715) is turned OFF and the "Actual cutting mode (thread, tap) in manual arbitrary reverse
run" (Y761) is turned OFF.
For the specific movement block, refer to the section "Actual cutting mode (thread, tap) in manual arbitrary reverse run
(Y761)".
[Related signals]
(1) Manual arbitrary reverse run mode (MORR: Y73C)
(2) Manual arbitrary reverse run mode ON (PCHKO: X715)
(3) Manual arbitrary reverse run speed selection (MORSP: Y73D)
(4) Actual cutting mode (thread, tap) in manual arbitrary reverse run (MRCMD: Y761)
(5) Manual arbitrary reverse run: MSTB reverse run prohibited (MRPSG: YCFC)
(6) Manual arbitrary reverse run speed multiplier (R379)
(7) Manual arbitrary reverse run: Reverse run ON (MOREV: X716)
(8) Manual arbitrary reverse run handle selection (R375)
IB-1501616-D
check ON
Abbrev. Common ($)
SPSCO X713
Abbrev. Common ($)
PNCMDO X714
168