Mitsubishi Electric M80V Series Manual page 621

M800V/M80V Series PLC Interface Manual
4 Explanation of Interface Signals
4.4 PLC Output Signals (Data Type: R***)
 Arbitrary setting of the number of tools per magazine (R10600/bit3)
The device assignment method of the magazine tool data is selected.
[When the number of tools per magazine is set to "No arbitrary setting" (R10600/bit3 = 0)]
There is a maximum of three rows of magazine, and the maximum number of tools that can be registered per magazine is
200.
The device assignment of the magazine tool data is fixed.
Refer to "[Example of tool data assignment when not setting arbitrarily]" for details.
[When the number of tools per magazine is set to "Arbitrary setting" (R10600/bit3 = 1)]
There is a maximum of five rows of magazine, and the total number of tools that can be registered for all the magazines is
600.
The device of the magazine tool data is assigned for the set tools in order from No. 1 magazine based on the set number
of tools.
Refer to "[Example of tool data assignment when setting arbitrarily]" for details.
 Number of tools per magazine
Regardless of arbitrary setting, set the number of tools to be registered for the magazine, in the following R registers of
each magazine.
No.1 magazine R10610
No.2 magazine R10611
No.3 magazine R10612
No.4 magazine R10613
No.5 magazine R10614
If there are any magazines not being used, set the designation register to "0".
To set the magazine tool arbitrarily (R10600/bit3 = 1), make sure that the number of tools is an even number.
IB-1501616-D 608