Mitsubishi Electric M80V Series Manual page 475

M800V/M80V Series PLC Interface Manual
4 Explanation of Interface Signals
4.3 PLC Output Signals (Bit Type: Y***)
Cont. Signal name
A Manual arbitrary feed Axis independent
[Function]
This signal can be used to position each axis independently without performing interpolation when two or more axis
components are moved simultaneously in the manual arbitrary feed mode.
[Operation]
When manual arbitrary feed is executed for two or more axes at the same time with "Manual arbitrary feed Axis
independent" (CXS2) turned ON, positioning is performed independently for each axis without interpolation. Normally, the
"Manual arbitrary feed Axis independent" (CXS2) signal is used when the "Manual arbitrary feed G0/G1" signal (CXS4)
described later is OFF (G0 selected).
Specific examples are shown below when the rapid traverse speeds of the X-axis and Z-axis are both 9600 mm/min, and
the movement amounts of the X-axis and Z-axis are 300 mm and 200 mm, respectively.
(Example 1)
End point
X-axis
300
f x
X-axis effective speed: 9600 mm/min
[Related signals]
For related signals, refer to the section on "Manual arbitrary feed mode" (PTP: YC03).
IB-1501616-D
Abbrev. $1 $2
CXS2 YCB9 YDF9
Z-axis
Z-axis effective speed:
9600 mm/min
f z
200
End point
Start point
X-axis
462
$3 $4 $5
YF39 Y1079 Y11B9
(Example 2)
Z-axis
300
f x
X-axis effective speed: 9600 mm/min
$6 $7 $8
Y12F9 Y1439 Y1579
Z-axis effective speed:
6400 mm/min
f z
200
Start point