Mitsubishi Electric M80V Series Manual page 620

M800V/M80V Series PLC Interface Manual
4 Explanation of Interface Signals
4.4 PLC Output Signals (Data Type: R***)
[When the pot head No. is set to "Arbitrary setting"]
Set pot head No. for each magazine in the following registers.
1st magazine pot head No. (R10695)
2nd magazine pot head No. (R10696)
3rd magazine pot head No. (R10697)
4th magazine pot head No. (R10698)
5th magazine pot head No. (R10699)
Note
(1) The pot head No. for each magazine is the value set in the register for "Pot head No. for each magazine" (R10695 to
R10699) regardless of "magazine No. start value" (R10600/bit1) of the ATC control parameter.
(2) Numerical value "0" to "8999" can be set in the register for "Pot head No. for each magazine" (R10695 to R10699).
When a value out of the range is set, pot No. is displayed from "1" or "0", depending on the setting of "magazine No.
start value" (R10600/bit1).
(Example 1) Pot head No. for each magazine: 10; number of tools for magazine: 12
Set the following R registers.
R10600 : 0x0004
o Number of digits for tool No. to be displayed: T4-digit
o Magazine No. start value
o Pot No. expansion
o Number of tools per magazine : No arbitrary setting
R10610 : 0x000C
o Number of tools for magazine 1 : 12
R10695 : 0x000A
o Pot head No. for magazine 1: 10
If the pot head No. for each magazine is outside the range of "0" to "8999", follow the setting for "magazine No. start
value".
(Example 2) Pot head No. for each magazine: 9000; number of tools for magazine: 12
Set the following R registers.
R10600 : 0x0006
o Number of digits for tool No. to be displayed : T4-digit
o Magazine No. start value
o Pot No. expansion
o Number of tools per magazine : No arbitrary setting
R10610 : 0x000C
o Number of tools for magazine 1 : 12
R10695 : 0x2328
o Pot head No. for magazine 1: 9000
: 1-start magazine
: Arbitrary setting
: 0-start magazine
: Arbitrary setting
607 IB-1501616-D