Mitsubishi Electric M80V Series Manual page 247

M800V/M80V Series PLC Interface Manual
4 Explanation of Interface Signals
4.1 PLC Input Signals (Bit Type: X***)
Cont. Signal name
Spindle-spindle polygon synchroniza-
A
tion completion
[Function]
This signal informs that the workpiece spindle and rotary tool spindle are in the synchronized rotation state.
[Operation]
This signal turns ON when:
 The rotary tool spindle rotation speed, in respect to the rotation speed following the rotary tool spindle and workpiece
spindle rotation ratio command, reaches the value set for the spindle-spindle polygon synchronization rotation speed
attainment level during the spindle-spindle polygon machining mode.
This signal turns OFF when:
 The rotary tool spindle rotation speed, in respect to the rotation speed following the rotary tool spindle and workpiece
spindle rotation ratio command, deviates from the value set for the spindle-spindle polygon synchronization rotation
speed attainment level during the spindle-spindle polygon machining mode.
 The spindle-spindle polygon synchronization mode is canceled.
[Related signals]
(1) Spindle-spindle polygon cancel (YCD1)
(2) In spindle-spindle polygon mode (XCB2)
Cont. Signal name
A In 3-dimensional coordinate conversion
[Function]
This signal notifies that the controller is in 3-dimensional coordinate conversion.
[Operation]
This signal turns ON when:
 G68 (M system)/G68.1 (L system) (3-dimensional coordinate conversion) is commanded.
This signal turns OFF when:
 G69 (M system)/G69.1 (L system) (3-dimensional coordinate conversion cancel) is commanded.
 G68/G68.1 (3-dimensional coordinate conversion) modal is cleared by reset.
IB-1501616-D
Abbrev. $1 $2
XCB3 XDF3 XF33
Abbrev. $1 $2
XCB9 XDF9 XF39
234
$3 $4 $5 $6
X1073 X11B3 X12F3
$3 $4 $5 $6
X1079 X11B9 X12F9
$7 $8
X1433 X1573
$7 $8
X1439 X1579