Mitsubishi Electric M80V Series Manual page 751

M800V/M80V Series PLC Interface Manual
6 Appx.2: List of PLC Window Data
6.2 Sub-section No. List
Section No.: 126 Base parameters
Significance of data
Sub-ID
No.
System No.
Not used.
System No.
Not used.
System No.
Not used.
System No.
Not used.
System No.
System No.
Not used.
Not used.
System No.
Not used.
System No.
Not used.
IB-1501616-D
Sub-section No. Details of Sub-section No.
1 System validation setup
2 System validation setup (PLC)
3 Number of axes
4 Number of axes (PLC)
5 Input setting unit
6 PLC unit
7 Control unit
8 Control unit (PLC)
10 Initial plane selection
11 Base axis I
12 Base axis J
13 Base axis K
14 Flat axis I
15 Flat axis J
16 Flat axis K
20 Command type
21 Ladder selection
22 Number of spindles
23 Constant input (inch)
24 Initial state (inch)
25 PLC axis command (inch)
26 Select language displayed
27 MR-J2-CT Connections
73 Initial absolute setting
74 Initial synchronous feed
75 Initial G00
76 ABS/INC address (for L system only)
77 Incremental command for diameter specification axis
78 Decimal point type 2
79 Validate F 1-digit
80 Specify boring axis (for M system only)
81 Give priority to G code parameter
82 Geometric
84 Arc error
85 G00 dry run
86 G00 non-interpolation
Constant surface speed control by rapid traverse feed
87
command
88 Disable G30 soft limit
91 Ignore middle point
92 Replace tools for additional axis
93 Synchronization between part systems method
94 Select life count for single block (for L system only)
95 TF output
96 Tool life management type
97 Tool wear compensation number 1-digit command
98 Tool length offset number
99 Cancel tool compensation amount
738
Data type R/W
Integer
Character string
RW
Integer