Table of Contents
Advertisement
Connecting the DB9 Port Framelock
Cable
Cable the Sun graphics accelerators before configuring your system for framelock
(described in "Configuring Graphics Accelerators for Framelocking" on page 50).
1. Locate the master Sun XVR-1200 graphics accelerator I/O backplate on the rear of
your system and its DB9 OUT connector (
Sun XVR-1200 Graphics Accelerator DB9/Framelock Connector
FIGURE 6-1
2. Connect one end of the DB9 framelock cable to the master DB9 OUT connector
(
).
FIGURE 6-2
Hand-tighten the DB9 cable connector thumb screws to secure it to the graphics
board DB9 connector.
3. Connect the other end of the framelock cable to a slave Sun XVR-1200 graphics
accelerator DB9 IN connector (
Hand-tighten the DB9 cable connector thumb screws to secure it to the graphics
board DB9 connector.
4. For additional slave Sun XVR-1200 graphics accelerators, connect the DB9 cable
from the OUT connector of the first slave graphics board to the second slave
graphics board (
FIGURE 6-2
FIGURE 6-1
1
2
OUT
DB9 framelock connectors
).
FIGURE 6-2
).
Chapter 6 Framelocking Sun XVR-1200 Graphics Accelerators
).
Stereo framelock
connector (DIN7)
IN
45
Advertisement
Table of Contents
