Renesas R-IN32M3 Series User Manual page 238

R-IN32M3-EC User's Manual
R-IN32M3-EC User's Manual
REVISION
HISTORY
Rev. Date
1.00 Feb. 8, 2013
(Preliminary)
1.00 Apr. 03,2013
1.01 Dec. 09 ,2013
2.00 Feb. 07,2014
Page
- First edition issued
Overall Modification of English expressions
Change the description of "CC-Link"
Overall
"CC-Link (Slave)" → "CC-Link (Remote device station)"
1 Modification of the contents of 1.1 Introduction
3 Standby mode deletion of Table1.1 Overview of R-IN32M3-EC
9 Modification of the status of BUSCLK during the reset of 2.1.2 External
Memory Interface Signals
Addition of synchronous burst access MEMC information of 2.1.2 External
Memory Interface Signals
10 Modification of the status of HD0-HD15, HBCYSTZ during the reset of 2.1.3
External MPU Interface Signals
21 Modification of PONRZ function of 2.1.16 System Signals
Addition the signals of HOTRESETZ, VDDQ_MII of 2.1.16 System Signals
24 Modification of the status of P40 of 2.2Port status
Modification of the contents of Note1 and Note2 of 2.2Port status
Overall Modification of the supported station of CC-Link
4 Addition of a connection of GPIO block and DMAC_RTPORT bus of 1.3
Internal block diagram
Addition of a connection of RealTimeGPIO block and DMAC bus of 1.3
Internal block diagram
6-24 Addition the status after reset timing of 2.1 Signals by function
21 Add CCM_CLK80M pins to list of 2.1.15 CC-Link Signals (Remote device
station)
22 Deletion the description about VDDQ_MII of 2.1.16 System Signals
24 Modification of Boot mode select of 2.1.18 Operation mode Setting Signals
25 Addition Synchronous burst MEMC of 2.2 Port status
28-29 Addition of a resister value of Pull up/down of 2.3.5 Port Signals
Modification of a description of the drive current of P10/P30/P31/P52 of 2.3.5
Port Signals
29 Modification of title name of 2.3.7 CC-Link Signal (Intelligent device station,
Remote device station)
30 Modification of the end address of EtherCAT area of Fig.3.1 Memory Map
(ALL)
33 Modification of the end address of EtherCAT area of Fig.3.5 External MPU
interface area
38 Addition of the contents of Note of INTCCSRFSTB register of 4.2 Interrupt list
41 Addition 6.2 Peripheral circuit of EtherCAT
47 Addition 7. Ether PHY Function
96 Modification of initial value of Fig.8.7 Port mode registers
Description
Summary
REVISION HISTORY
REVISION-1