Renesas R-IN32M3 Series User Manual page 16

R-IN32M3-EC User's Manual
Item
Internal peripheral circuit
Watchdog timer
Asynchronous serial interface
I2C serial interface
CAN controller
Clock synchronous serial interface - 2 channels
CC-Link
Note2
10/100-Mbps EtherPHY
EtherCAT
On-chip debug function
Internal PLL
Power supply voltage
Note 1. Please contact our sales representative for details.
2. EtherCAT P is not supported.
R18UZ0003EJ0501
Jan. 12, 2021
Product
- 1 channel
- Software-triggered start mode
- Selectable operations in response to errors:
- Generation of a non-maskable interrupt (NMIZ)
- Generation of a reset
- 2 channels
- Full duplex
- FIFOs: 10 bits x 16 receive and 8 bits x 16 transmit
- Support output of receive errors and status
- Character length: 7 or 8 bits
- Parity bit options: Odd, even, 0, none
- Transmit stop bits: 1 or 2 bits
- 2 channels
- Operating modes: Normal or high-speed
- Transfer modes: Single-transfer mode or continuous-transfer mode
- Transmission data length: 8 bits
- 2 channels
- Conforming to ISO11898
- Support to transfer and receive normal frame and expand frame
- Transmission speed: 1 Mbps (max)
- Synchronized serial data transmission by three-wire system
- Selectable master mode or slave mode
- Built-in baud-rate generator
- Transmission data length: 7 bits to 16 bits
- Intelligent device station
- Remote device station
- 2 ports
- Support 10BaseT and 100Base TX/FX
®
EtherCAT slave controller
- Select serial wire or JTAG
- Support Full Trace (Built-in ETM)
Generates various clocks from 25-MHz input clock
I/O: VDD33 = 3.3±0.3 V
Internal circuit: VDD10 = 1.0±0.1 V
On-chip PHY: VDD15 = 1.5±0.15 V (on-chip regulator is available.)
<R>
R-IN32M3-EC
Note1
1. Overview
(2/2)
Page 3 of 224