Digital Control Troubleshooting
Run the Internal Diagnostic Tests
Run the Internal Diagnostic Tests
The analyzer incorporates 20 internal diagnostic tests. Most tests can be run as part of one
or both major test sequences: all internal (test 0) and preset (test 1).
1. Press
SERVICE MENU
System
INT tests.
2. Then press
1
x1
the
keys to find the first occurrence of a FAIL message for tests 2 through
20. See
Table 6-2
6-16
TESTS
to see the results of the preset test. If either sequence fails, press
for further troubleshooting information.
EXECUTE TEST
0
x1
to perform all
Chapter 6