A8, A10, A11, A12, A13, A14 Card Cage Boards - Agilent Technologies 8753ES Option 011 Service Manual

Network analyzer

Hide thumbs Also See for 8753ES Option 011:

Table of Contents

Assembly Replacement and Post-Repair Procedures

A8, A10, A11, A12, A13, A14 Card Cage Boards

Tools Required

• T-10 TORX screwdriver

• T-15 TORX screwdriver

• ESD (electrostatic discharge) grounding wrist strap

1. Disconnect the power cord and remove the top cover (refer to

2. Remove the screw from the pc board stabilizer and remove the stabilizer.

3. Lift the two extractors located at each end of the board. Lift the board from the card

cage slot, just enough to disconnect any flexible cables that may be connected to it.

4. Remove the board from the card cage slot.

1. Check the connector pins on the motherboard before reinstallation.

2. Reverse the order of the removal procedure.

Be sure to route W8 and W9 as shown. No excess wire should be hanging in

the A11 and A14 board slots. Routing the wires in this manner will reduce

noise and crosstalk in the instrument.

"Covers" on page