Assembly Replacement and Post-Repair Procedures
B1 Fan Assembly
B1 Fan Assembly
Tools Required
• 2.5-mm hex-key driver
• T-10 TORX screwdriver
• T-15 TORX screwdriver
• ESD (electrostatic discharge) grounding wrist strap
Removal
1. Remove the rear panel (refer to
2. Remove the four screws (item 1) that secure the fan and fan cover to the rear panel.
Replacement
1. Reverse the order of the removal procedure.
The fan should be installed so that the direction of the air flow is away from
NOTE
the instrument. There is an arrow on the fan chassis indicating the air flow
direction.
Figure 14-20
B1 Fan Assembly
14-42
"Rear Panel Assembly" on page
14-14).
Chapter 14