Agilent Technologies 8753ES Option 011 Service Manual page 463

Test the disk-eject function, and adjust if required.
1. Insert a diskette into the disk drive and then eject the disk.
2. If the diskette does not eject properly, loosen and then retighten the three screws that
hold the disk drive to the disk drive bracket:
a. Loosen the three screws that are readily accessible.
b. Loosen the upper-most front screw through the screw hole left empty in step 7 on
page 14-38.
c. Center the disk drive in the opening.
d. Retighten all three screws.
Reinstall the front panel and covers
1. Reinstall the top left screw under the trim strip.
2. Reinstall the trim strip.
3. Reinstall the covers. If necessary, refer to
with this task.
Chapter 14
Assembly Replacement and Post-Repair Procedures
"Front Panel Assembly" on page 14-8
A20 Disk Drive Assembly
for help
14-39