Assembly Replacement and Post-Repair Procedures
Type-N Connector Assembly
Type-N Connector Assembly
Tools Required
• T-10 TORX screwdriver
• T-15 TORX screwdriver
• small slot screwdriver
• ESD (electrostatic discharge) grounding wrist strap
• 5/16-inch open-end torque wrench (set to 10 in-lb)
Removal
1. Disconnect the power cord.
2. Remove the front panel (refer to
3. Remove the right-side trim strip (item 1) from the front frame. Remove the screw
(item 2) that secures the right end of the type-N connector bracket.
4. Remove the three screws (item 3) from the bottom edge of the front frame that secure
the connector bracket.
5. Disconnect the semirigid cables (W1, W2, W3, and W4) from the type-N connector
assembly.
6. Remove the connector assembly (item 4).
Replacement
1. Reverse the order of the removal procedure.
NOTE
When reconnecting semirigid cables, it is recommended that the connections
be torqued to 10 in-lb.
14-18
"Front Panel Assembly" on page
14-8).
Chapter 14