Table of Contents
Advertisement
• Retrieve the original shipping carton and packing materials. Contact your JTAC representative if you
do not have these materials, to learn about approved packing materials. See
Support to Obtain a Return Material Authorization" on page
Ensure that you have the following parts and tools available:
• ESD grounding strap.
• Antistatic bag, one for each component.
• If you are returning the chassis, an appropriate screwdriver for the mounting screws used on your
rack or cabinet.
This topic describes:
Packing a QFX5130-32CD Switch for Shipping
To pack a QFX5130-32CD for shipping:
1.
Power down the switch and remove the power cables. See
page
113.
2.
Remove the cables that connect the QFX5130-32CD to all external devices.
3.
Remove all field-replaceable units (FRUs) from the switch.
4.
Have one person support the weight of the switch while another person unscrews and removes the
mounting screws.
5.
Remove the switch from the rack or cabinet (see
71) and place the switch in a large antistatic bag.
6.
Place the switch in the shipping carton.
7.
Place the packing foam on top of and around the switch.
8.
If you are returning accessories or FRUs with the switch, pack them as instructed in
QFX5130-32CD Components for Shipping" on page
9.
Replace the accessory box on top of the packing foam.
10. Close the top of the cardboard shipping box and seal it with packing tape.
11. Write the RMA number on the exterior of the box to ensure proper tracking.
Packing QFX5130-32CD Components for Shipping
CAUTION: Do not stack switch components. Return individual components in separate
boxes if they do not fit together on one level in the shipping box.
To pack and ship QFX5130-32CD components:
• Place individual FRUs in antistatic bags.
123.
"Powering Off a QFX5130-32CD" on
"QFX5130 Installation Safety Guidelines" on page
132.
"Contact Customer
"Packing
132
Advertisement
Table of Contents
Troubleshooting
