Packing An Ex4600 Switch Or Component For Shipping; Packing An Ex4600 Switch For Shipping - Juniper EX4600 Hardware Manual

Packing an EX4600 Switch or Component for Shipping

IN THIS SECTION

Packing an EX4600 Switch for Shipping | 133

Packing EX4600 Switch Components for Shipping | 134
If you are returning an EX4600 switch or component to Juniper Networks for repair or replacement,
pack the item as described in this topic.
Before you pack an EX4600 switch or component:
• Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD)
Prevention of Electrostatic Discharge Damage
damage. See
• Retrieve the original shipping carton and packing materials. Contact your JTAC representative if you
do not have these materials, to learn about approved packing materials. See
Support to Obtain Return Material Authorization
Ensure that you have the following parts and tools available:
• ESD grounding strap.
• Antistatic bag, one for each component.
• If you are returning the chassis, an appropriate screwdriver for the mounting screws used on your
rack or cabinet.
Packing an EX4600 Switch for Shipping
To pack an EX4600 switch for shipping:
1. Power down the switch and remove the power cables. See
page 115.
2. Remove the cables that connect the EX4600 switch to all external devices.
3. Remove all field-replaceable units (FRUs) from the switch.
4. Have one person support the weight of the switch while another person unscrews and removes the
mounting screws.
5. Remove the switch from the rack or cabinet (see
and place the switch in an antistatic bag.
6. Place the switch in the shipping carton.
.
.
"Powering Off an EX4600 Switch" on
Chassis Lifting Guidelines for an EX4600
Contact Customer
Switch)
133