Unpacking And Mounting The Ex9253 Switch; Unpacking An Ex9253 Switch - Juniper EX9253 Hardware Manual

Unpacking and Mounting the EX9253 Switch

IN THIS SECTION

Unpacking an EX9253 Switch | 73

Parts Inventory (Packing List) for an EX9253 Switch | 74
Unpacking a Line Card Used in an EX9253 Switch | 76
Register Products—Mandatory to Validate SLAs | 77
Installing and Connecting an EX9253 Switch | 77
Mounting an EX9253 Switch on a Rack or Cabinet | 78
Unpacking an EX9253 Switch
The switch is shipped in a cardboard carton and secured with foam packing material. The carton also
contains an accessory box.
NOTE: The switch is maximally protected inside the shipping box. Do not unpack it until you are
ready to begin installation.
Ensure that you have the following parts and tools available:
• A Phillips (+) screwdrivers, number 2 (not provided)
• Cover panels to cover any slots not occupied by a component
To unpack the switch:
1. Move the shipping carton to a staging area as close to the installation site as possible, where you
have enough room to remove the switch.
2. Position the carton so that the arrows are pointing up.
3. Open the top flaps on the shipping carton.
4. Remove the accessory box, and verify the contents against the parts inventory on the label attached
to the carton.
5. Pull out the packing material holding the chassis in place.
73