Privilege Level 15 Commands; Auth - Cisco CiscoWorks 1105 User Manual

Appendix B Command Reference

Privilege Level 15 Commands

auth

Syntax Description
78-14947-01
This section describes the privilege level 15 commands. Only users with privilege
level 15 can run these commands.
Use the auth command to enable secure remote authentication.
auth {cli | http} {local | tacacs secret server1 [server2] | radius secret
server1 [server2] | nt domain pdc [bdc]}
cli Enables authentication using the Command Line Interface
(CLI).
http Enables authentication using Hypertext Transfer Protocol
(HTTP).
local Enables local authentication.
tacacs Enables authentication using the Terminal Access Controller
Access Control System (TACACS).
radius Enables authentication using Remote Dial-In User Service
(RADIUS).
nt Enables authentication from an NT domain controller.
secret Shared secret code of server.
server1 IP address or device name of server from which
authentication will occur.
server2 IP address or device name of optional secondary server from
which authentication could occur
domain NT domain name.
pdc Name of the Primary Domain Controller (PDC).
bdc Name of the Backup Domain Controller (BDC).
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
Privilege Level 15 Commands
B-17