Cisco CiscoWorks 1105 User Manual page 132

Using the Templates
Table 3-23 11a Radio Hardware Settings (continued)
Field
Data Rates (Mb/sec)
6.0
9.0
12.0
18.0
24.0
36.0
48.0
54.0
Transmit Power
Fragmentation Threshold
(256-2338)
RTS Threshold (0-2339)
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
3-78
Chapter 3
Description
From the list, select one of the following for
each of the four rates in megabits per second:
• basic—Allows transmission at this rate
for all packets, both unicast and
multicast. At least one data rate must be
set to basic.
• yes—Allows transmission at this rate for
unicast packets only.
no—Does not allow transmission at this
•
rate.
From the list, select one of the following
milliwatt settings: 5, 10, 20, 40.
To reduce interference or to conserve power,
select a lower power setting.
Click see details to see which versions this
setting is valid for.
Enter a setting to determine the size at which
packets are fragmented (sent as several
pieces instead of as one block).
Use a low setting in areas where
communication is poor or where there is a
great deal of radio interference.
Enter a setting to determine the packet size at
which the access point issues a request to
send (RTS) before sending the packet.
A low RTS Threshold setting can be useful in
areas where many client devices are
associating with the access point, or in areas
where the clients are far apart and can detect
only the access point and not each other.
Configuring Devices
78-14947-01