Cisco CiscoWorks 1105 User Manual page 321

Chapter 6 Performing Administrative Tasks
Set Up Routers and Switches
Note
Table 6-5 Set Up Procedures for Routers and Switches
Task Procedure
1. Enable CDP 1.
and verify that
2.
access points and
bridges are
visible from the
router or switch.
3.
4.
2. Enable SNMP On IOS-based devices, enter configuration mode
and set up and use the snmp community community_string ro
community command.
strings.
On Hybrid OS-based Catalyst devices, enter enable
mode and use the set snmp community read-only
community_string command.
78-14947-01
Only routers and switches that have properly configured access points or bridges
attached to them will be discovered.
On each router and switch, configure the following:
Enter enable mode.
Verify that CDP is running on the switch or
router:
On IOS-based devices, use the show cdp run
command.
On Hybrid OS-based Catalyst switches, use the
show cdp command
If CDP is not running, use the set cdp enable
command to enable CDP.
To verify that access points or bridges are
visible in the device's CDP table, use the show
cdp neighbors command.
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
Using Discovery and Managing Devices
Notes
CDP is required for the
WLSE to discover the
device.
SNMP is required for the
WLSE to discover and
manage the device.
6-15