Cisco CiscoWorks 1105 User Manual page 164

Using the Templates
Complete the following:
Step 2
Note
Table 3-32 Hot Standby Settings
Field
Hot Standby Mode
Service Set ID (SSID)
MAC Address for the
Monitored AP
Polling Frequency (1-30)
Timeout for Each Polling
(1-600)
Select one of the following in the left pane:
Step 3
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
3-110
Clicking Clear removes all the current entries in the window and any
entries you have made in other Template windows up until that point.
• Preview to see your changes before you apply them. (See
Template, page 3-131.)
• Finish to save the template. (See
Another template category to configure more options. (See
•
Categories, page 3-2.)
Description
From the list, select one of the following:
• Enable—Use this setting to allow hot standby
mode.
Disable—Use this setting to disable hot
•
standby mode.
Enter the monitored access point's SSID.
Enter the monitored access point's MAC address.
Enter the number of seconds between each query
the standby access point sends to the monitored
access point.
Enter the number of seconds the standby access
point should wait for a response from the
monitored access point before it assumes that the
monitored access point has malfunctioned.
Finishing the Template, page
Chapter 3 Configuring Devices
Previewing the
3-132.)
Template
78-14947-01