Cisco CiscoWorks 1105 User Manual page 154

Using the Templates
Table 3-29 Server-Based Security Settings (continued)
Field
Server Type
Port
Shared Secret
Retran Int (sec)
Time Out (sec's)
EAP Auth
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
3-100
Chapter 3
Description
Enter the type of server.
Click * (asterisk) for information on which
version this setting is valid
Enter the port number your server uses for
authentication.
Enter the shared secret used by your server. It
must match the shared secret on the RADIUS
server.
Enter the number of seconds the access point
should wait before retransmitting.
Click * (asterisk) for information on which
version this setting is valid.
Enter the number of seconds the access point
should wait before authentication fails.
If the server does not respond within this
time, the access point tries to contact the next
defined authentication server.
From the list, select one of the following:
• Yes—Use this server for EAP
authentication.
In this type of authentication, the access
point relays authentication messages
between the server and the
authenticating client device.
• No—Do not use this server for EAP
authentication.
Click * (asterisk) for information on which
version this setting is valid.
Configuring Devices
78-14947-01