Cisco CiscoWorks 1105 User Manual page 162

Using the Templates
Table 3-31 Console/Telnet Settings
Field
Baud Rate
Parity
Data Bits
Stop Bits
Flow Control
Terminal Type
User Guide for the CiscoWorks 1105 Wireless LAN Solution Engine
3-108
Chapter 3
Description
Enter a rate from 110 to 115,200, expressed
in bits per second.
The rate you enter is dependent on the
capability of the computer you use to open
the access point management system.
From the list, select one of the following:
• None—Use this setting to use no parity
bit.
• Even—Use this setting to make the total
number of bits even.
• Odd—Use this setting to make the total
number of bits odd.
From the list, select one of the data bit
settings.
From the list, select one of the stop bit
settings.
From the list, select one of the following:
• None—Use this setting to indicate no
flow control is used.
• SW Xonn/Xoff—Use this setting to
indicate the method information is sent
between pieces of equipment to prevent
loss of data when too much information
arrives at the same time on one device.
From the list, select one of the following:
• teletype—Use this setting if your
terminal emulator does not support
ANSI.
ANSI—Use this setting to offer graphic
•
features such as reverse video buttons
and underlined links.
Configuring Devices
78-14947-01